Installation Guide
Case components
C50.Q2600.00E
Remove side panels Motherboard installation
Place the M/B onto the copper bolt
and fasten screws to secure.
Hardware list
Dual LED
Power switch
(Blue LED for power)
(Red LED for HDD)
Multi-media ports
120 mm fan
Ventilation holes
in the PCI slots
Female clip
2.5" HDD mount
120 mm fans x 3
Removable
PSU bracket
3.5" HDD cage
for 3.5" HDD x 10
(Hot swap x 2)
Pull side panel out to
remove.
Extra quantities are spare parts.
Clamp (2)
Buzzer (1)
Cable ties (1)
Screws (5)
for M/B
Screws (5)
for PSU mounting
Screws M3*9.5 (5)
for 2.5" HDD
Anti-vibration rubber rings (5)
for 2.5" HDD / 3.5" HDD
Anti-vibration silica gel rings (44)
for 3.5" HDD
Thumb screws (44)
for 3.5" HDD
Install screws along with
anti-vibration rubber rings
onto the HDD.
2.5" HDD installation
3.5" HDD installation-1 (hot swap)
Close the gate to secure
the HDD.
Slide the HDD into the
HDD cage.
Install screws along with
anti-vibration silica gel rings
onto the 3.5" HDD.
Slide the HDD into the
holes on the HDD platform.
I/O port installation
HD AUDIO
BLUE
BLACK PURPLE
YELLOW
GRAY
RED
10
8
6
4
2
9
7
5
3
1
GREEN
KEY
ORANGE
N.C.
GND+H.S. TUBE
11
20
10
1
USB 3.0
Supports motherboard
USB 3.0 20 Pin header
Cable guideinstallation
POWER SW
BLACK / WHITE
BLACK
POWER LED
POWER LED
BLACK -
BLACK / WHITE +
HDD LED
BLACK / WHITE -
BLACK +
SPEAKER
RED+
NC
NC
Blue
PSU installation
Loose 4 thumb screws to
remove the PSU
mounting bracket.
Push in gently.Assembly power supply with
PSU mounting bracket.
Fasten 4 thumb screws
to secure.
Removing fan modules
Slide the anti-vibration fan sideways to remove.
Cable management
Press to release.
Remove air filters
Reserved hole for
fan
(Fan is not included)
installation 120 mm
Removable
air filter
Comments to this Manuals